• Pit Wheel-Free Jack with 3.5 t load capacity and 10 t drive-over axle load
• Flush-floor installation, no mechanical connection between the scissors
• 10 t drive-over axle load, ideal for use in pits servicing commercial vehicles
• Automatic leveling in lowered position
• Foundation installation frame as permanent form, supplied separately in advance
• Generous lifting height of 450 mm
  
  
  With 3.5 t load capacity and 10 t drive-over axle load
  
  Flush-floor installation, no mechanical connection between the scissors
  ► 10 t drive-over axle load, ideal for use in pits servicing commercial vehicles
  ► Automatic leveling in lowered position
  ► Foundation installation frame as permanent form, supplied separately in advance
  ► Generous lifting height of 450 mm

Technical Data
Load capacity	3500 kg
Axle load drive-over	10 t
Lifting height H	450 mm
Width of lifting plate B	683 mm
Lifting- / lowering time load-dependent ca.	9 s / 9 s
Extension length L min / L max	1500 m - 2000 mm
Installation depth	260 mm
Supply voltage	3 x 400 V / 50 Hz
Autofeed 2	IP 54

Upright operations desk.with small outside dimensions
Additional operational unit in the pit with safety switch and EMERGENCY OFF
Release light for driveover when lift is completely lowered.
Two cylinders on each scissor side for high safety.
Installation over pit, without mechanical connection between the scissors.
Lifting pads with granulate coating for excellent anti-slip properties, also for
persons when stepping on them. Lifting pads can also be extended when lift is in a lowered position.

► Large extension lengths from 1500 – 2000 mm
► Lifting plates with large width
► Short lifting and lowering times of 9 s / 9 s
► Cylinder placement on the outside scissors providing high side stability even with uncentered load
► No compressed air needed
► Inclusive of emergency lowering device, easy and safe to operate located on operations desk
► Aluminum traverse with low net weight (optional) for lifting of vehicles with deeply recessed lifting points.